Recon 26414-26414X BIG RIG & BIG RIG ICE Running Lig Bedienungsanleitung PDF herunterladen

26413 - 26413X - 26414 - 26414X - Installation Instructions RECON BIG RIG & BIG RIG ICE LED Running Light Kitss

Installation Instructions for RECON BIG RIG LED Running Light Kit &

Supplemental Installation Sheet for BIG RIG “ICE” Running Light Kit

1. Remove all contents from the box. Each 48” & 62” kit contains the following:

a. Two amber L.E.D. bars with Three wires coming out of each light bar

b. Ten metal brackets in 48” kit & Twelve metal brackets in 62” kit

c. Ten self tapping screws in 48” kit & 12 self tapping screws in 62” kit

d. Four male and Four female 3M wire splice connectors

e. Eight plastic “zip-tie” wire loom fastemers

2. First identify which is the drivers side bar and which is the passenger side bar. Keep in mind that the

wires coming out of each bar should come out towards the front of the truck. Evenly space out and

attach half the metal brackets contained in the kit to the drivers side bar (be careful not to cover any

of the L.E.D.’s with the brackets). The top of the bar will be black and you should be able to see the

L.E.D.’s inside the bar. The bar will be angled downward slightly when installed properly. “See figure 1”

Figure 1

3. Once all 5 brackets have been screwed into the flat metal surface directly beneath your drivers side

door(s) aka pinch well, rocker panel, or frame rail, you are ready to begin plumbing the 3 wires behind

the front wheel dirt-guard and then up in front of the firewall to the engine bay. You will splice the

positive wires at the drivers side front corner marker lens. “See figure 2 next page” The three wires

are labeled as follows:

a. YELLOW Wire – Running Light Positive Wire

b. RED Wire – Turn Signal Positive Wire

c. BLACK Wire – Negative / Ground Wire

d. WHITE Wire – Courtesy Light Positive Wire (**Only Found On BIG RIG “ICE” KIT**)

4. The next step is to remove the corner marker lens and use the included splice connectors to splice

each of the positive wires to the cooresponding positive wire coming off the bulb plug in your corner

marker lens. “See figure 3 & 4 next page”. Next you will need to ground the Black Wire to a metal

surface preferrably under a metal screw located near the corner marker lens or under the hood.

1 2 3 4

Seite 1

26413 - 26413X - 26414 - 26414X - Installation Instructions RECON BIG RIG & BIG RIG ICE LED Running Light Kitss Installation Instructions for RE

26413 - 26413X - 26414 - 26414X - Installation Instructions RECON BIG RIG & BIG RIG ICE LED Running Light Kitss Figure 2 Figure 3

26413 - 26413X - 26414 - 26414X - Installation Instructions RECON BIG RIG & BIG RIG ICE LED Running Light Kitss Figure 4 5. Now you are ready

Seite 4

26413 - 26413X - 26414 - 26414X - Installation Instructions RECON BIG RIG & BIG RIG ICE LED Running Light Kitss HOW TO INSTALL 26413X & 26

Keine Kommentare

Recon 26414-26414X BIG RIG & BIG RIG ICE Running Lig Bedienungsanleitung