Recon 264150 - How To Replace H3 Bulb Bedienungsanleitung PDF herunterladen

264150 Bulb Replacement How‐To Page 1

In This DIY I Will Explain How To Replace The H3 Bulb In RECON: Backup Projectors

Tools Required: Medium – Small, Sized Phillips Screwdriver

What You Need To Get:

New H# 55W Bulb

________________________________________________________________________________________

You Will First Need To Remove The Two Phillips Screws On The Side of Your

Recons. *NOTE The Order of The Washers. – Disconnect The Terminals.

‐ Place Your Projector On A Solid Surface To Work On

‐ Flip The Projector Upside Down – To Expose The Silver Access Plate

‐ Remove The 3 Phillips Screws To Remove The Access Plate – Set Aside.

‐ Examine How The Bulb Is Installed From The Factory

‐ Remove The Screw Holding The Ground Terminal & The Bulb Keeper – Set Aside

‐ Remove The Bad Bulb, Wiggle Back And Fourth Until Bulb Separates From The Housing

‐ Install The New Bulb

‐ Reassemble Following Tear Down Procedure.

‐ The Ground and Power Wire Have Channels To Lay In

‐ Be Sure The Cover Plate and Gasket Have A Good Seal, Be Sure Not To Over Tighten.

Visit Us Online at: www.GoRECON.com

264150 Bulb Replacement How‐To Page 1 In This DIY I Will Explain How To Replace The H3 Bulb In RECON: Backup Projectors Tools Required: Medium – S

Keine Kommentare

Recon 264150 - How To Replace H3 Bulb Bedienungsanleitung