1 | Page Here I Will Explain How To Install Recon Cab Lights In A 3rd Gen Dodge Ram. *Now, There Are Many Ways of Installing Them, Including Wi
10 | Page -Now Place The Cab Light On The Mark You Made From The Windshield, Line Up The Screw Holes So You Can See The Line Through The Hole. -If
11 | Page - You Are Now Set To Wire - Wire and Cab Light Install -There Are Many Ways To Wire to Your Cab Lights. There Is No Harm Is Using Wire
12 | Page -Tape The Wires To Prevent any Grounding Issues -Now You have A Tree Branch Like Harness to Wire Your Lights Up, Repeat These Steps To Cr
13 | Page -Connect Each Recon To The Power Wire First -Push The Power Wire Through Roof, and Pull The Ground Wire Up and Connect. -Push The Gro
14 | Page -Apply Some Goop Under The Roof Also -With The Wires Ran Into Cab, Be Sure To Tape and Secure All Connections to Prevent Any Lose or
15 | Page Connecting To Your Factory Power and Ground This Step Will Range From Each 3rd Gen Model Ram, A Voltage Meter Is Great Tool To Locate Th
16 | Page Reinstall Headliner and Test You Can Now Test Your Lights To Make Sure All Connections Are Made and Lights Are Working Properly. If All
2 | Page Tools Required: A Good Assortment of Hand Tools is Recommended, Required Hand tools are as Followed: • Wet Erase Marker • Cordless
3 | Page On To The Tear Down. It Is Not Required, but Disconnecting Your Batteries Negative Cable Is Recommended Start by Removing the Front Driv
4 | Page Remove Overhead Display W/ Lights -Remove The Light Covers (2) With Flat Head Screwdriver (Pry Till' They Unclip, Gently) -Remove
5 | Page Remove Door Pillar & Seat Belt Bolt -With Flat Head Screwdriver Pop Off Caps on Rear Grab handle - Driver & Passenger -Remove (
6 | Page Roof Layout and Drilling With Proper Measurement, And A Confident Installer, Drilling The 15 Holes Should Not Be An Issue -This Part
7 | Page *** On This Application I Started My Tape Measuring From The Driver Side *** Read Carefully! : With This Application I Found The facto
8 | Page -That Being Said The Right Most Cab Light and The Left Most Cab Light Will Be At 5.5" (On Center) At The Top Measuring Tape, and 6.5&qu
9 | Page Now The 2nd and The 4th Cab Light Can Be Measured 3 Ways: • 12.5" From The 1st and 5th Cab Light Mark (Top Tape and Bottom Tape) •
Kommentare zu diesen Handbüchern